• Skip to main content
  • Skip to header right navigation
  • Skip to after header navigation
  • Skip to site footer
Jeepfan.com

Jeepfan.com

serving the Jeep community since 1997

  • Projects & Installs
  • Offroading & Events
  • Technical & Info
  • Readers Jeeps
  • Jeep Racing
  • Products
  • Ask
  • jeepfan.com 2022 4xe
  • jeepfan.com 2018 JL
  • jeepfan.com 2004 TJ Unlimited
  • jeepfan.com 1978 CJ-5

News

78 Jeep CJ-5 Frame Replacement – Part 2

Rocker Guard Fabrication and Roll Bar Frame Mounts

Jeep Spotters Guide – Part 2

Below is a chart giving information on various commonly found Jeep vehicles including model years, names, tech info, etc…If you find any discrepancies in this chart or have any thing to add click here to send us a message.

78 Jeep CJ-5 Frame Replacement – Part 1

The jeepfan.com 1978 CJ-5 has almost no original major parts left on it except the frame, grill, and hood. There has always been little rust concerns for me since the Jeep stays in a garage and the body is fiberglass. Recently concerns for the frame’s well being have been growing. In the section under the …

Jeep Spotters Guide

Below is a chart giving information on various commonly found Jeep vehicles including model years, names, tech info, etc…If you find any discrepancies in this chart or have any thing to add click here to send us a message.

T-18A Rebuild and Short Shaft Kit – Part 3

Next we packed needle bearings into lower shaft. Used petroleum jelly to hold it all together. The petroleum jelly will disintegrate once exposed to the gear oil. This is where the one inch dowel rod comes into play. Each bearings set gets 22 bearings. The bearings go in in specific order with the tub in …

T-18A Rebuild and Short Shaft Kit – Part 2

We kick off the project by removing the top of the T-18A exposing all the guts of the beast. Removal of the stick shift is not necessary. Behind the workbench was a table where we could layout all the pieces.

T-18A Rebuild and Short Shaft Kit

Originally the T-18A manual transmission came out of a J-20 Pickup and the T-18A’s input shaft ran though a 5 inch adapter before emerging into the bell housing. This T-18A’s new life will be lived out in a CJ-7 which has a shorter wheelbase when compared to the J-20. To properly fit the transmission into …

Jeep Advertisements

Over the years we have collected these Jeep ads from all over the internet.

Painless Wiring All-Weather 7 Circuit Fuse Block

After looking at the jeepfan.com CJ-5‘s wiring for a while it became evident that there are several of those in-line style fuses scattered around the engine compartment. Some of them are practically impossible to get at without removing the passenger side fender. This would make for a real hassle on the trail if access to one of …

Deb’s 97 TJ Wrangler

Deb recently traded her TJ for a new Grand Cherokee.  Chris Van Nest of Trekken.tv purchased the Jeep and is now working on a build-up featured on his show. Before Deb’s 97 TJ is a classy looking Jeep.  It is equipped with a 3″ Tera-Flex lift and 33X12.50 BFG Mud Terrains. On the front and …

  • Previous
  • Page 1
  • Interim pages omitted …
  • Page 95
  • Page 96
  • Page 97
  • Page 98
  • Page 99
  • Interim pages omitted …
  • Page 103
  • Next

Receive exclusive recommendations directly from our website.

Sidebar


Jeep CJ 1972-1986 How to Build and Modify

Grab Your CopyJeep CJ 1972-1986 How to Build and Modify

jeepfan.com

  • Instagram
  • Facebook
  • Twitter
  • YouTube

© 2025 · jeepfan.com · Powered by Bizbudding

Privacy Manager

Explore

  • Projects & Installs
  • Technical & Info
  • Offroading & Events
  • Products
  • Racing
  • Readers Jeeps
  • Jeep News & Information jeepfan.com blog

About

  • Contact
  • Advertise
  • About
  • Terms of Use

Partners

  • Quadratec
  • Rough Country
  • TeraFlex
  • Maximus 3
  • 7S Garage
  • OK Auto