Mopar Jeep Wrangler JK Bumper Installation
Harry included a set of Mopar JK Rock Bumpers when he ordered his 2008 JK Wrangler Unlimited. After a few months of taking up basement space we decided to install them.
how-to
Installing BDS Caster Adjusting Bolts
After a lift on a Wrangler JK these simple bolts set the caster back where it belongs.
Wrangler JK Power Locks
QUESTION: I’ve got an 08 Unlimted X and have a question about the power locks. I want to get an “add-a-trunk” and most of those are lockable based on the tailgate being locked. Problem is, if the top is off, the power lock switch is accessable on the door and switching it unlocks the tailgate. …
BDS 3″ Lift for Wrangler JK Rubicon – Part 4
Installing the Rear Raise the Jeep and support by jack stands under the frame in front of the rear control arm mounts. We also add additional support for the rear of the Jeep with a high lift jack under the rear bumper. Keep the rear axle supported by a floor jack at close to ride …
BDS 3″ Lift for Wrangler JK Rubicon – Part 3
Install the front springs with the spacer inside the spring. Using the fasteners provided attach the bump stop spacers to the spring pad.
BDS 3″ Lift for Wrangler JK Rubicon – Part 2
As with all projects we write about here at jeepfan.com safety is a top priority. Make sure the Jeep is properly secured when supported by something other than on all fours. Use properly rated jack stands. Also, these articles may not lift all the small details involved in an install. Make sure you are capable …
BDS 3″ Lift for Wrangler JK Rubicon
In the early stages of the jeepfan.com JK we installed a 2.5″ Tera Flex Budget Boost lift kit. The kit has served the Jeep well in the year it was installed but it has come time to upgrade to a “real” lift that includes shocks, springs, etc.
CoolTech Wrangler JK CB Antenna Mount
A clever CB antenna mount that hides in the JK license plate mount.
Poweraid Throttle Spacer and Airaid Cold Air Intake install – Part 2
Installation Steps and Tips Continued After removing the temp sensor continue by removing the four bolts in the throttle body and pull the throttle body out. Install the spacer then the gasket then using the supplied bolts reinstall the throttle body.
Poweraid Throttle Spacer and Airaid Cold Air Intake install
Adding a little more oomph and some extra MPG to Christine’s JK. Having a nice new lift, new tires and wheels, and some other mods Christine’s JK needed some extras under the hood to help the performance and efficiency of the 3.8L V6.