tech
Jeep Tie
Rod and Drag Link End Identification
information provided
by Parts
Mike
There are many 4X4 Internet
sites and companies that make reference to custom steering
components and list ES2233L and ES2234R tie rod ends as
being �1 Ton� parts. These are actually GM � - � ton K/V
series tie rod ends used on 1976-1991 second generation
vehicles.
The drag link ends ES2026R and ES2027L were used on GM �, �
and 1 ton K series vehicles and use a larger taper. Both of
these ends have 60 degrees of motion.
GM Dana 60 1 ton front axles use the same taper through the
steering arm as ES2233L and ES2234R but have a 1� X 18tpi
thread; part number ES2064L and ES2011R.
Dodge 4X4 W250/W350 trucks that have a 4500Lb front axle
used ES2010R & L tie rod ends.
Full sized Jeeps used ES453L which is the same as the
ES2010R & L other then it uses a smaller diameter retaining
nut. Taper and length dimensions:
Part Number |
Thread/Diameter |
length of thread |
Taper length |
major/minor
diameters |
length |
*ES2010R |
.875x18tpi |
1.750� |
.808 |
.773 x .664 |
3.38� |
*ES453L |
.875x18tpi |
1.750� |
.808 |
.773 x .664 |
3.38� |
ES2026R |
.875x18tpi |
2.50� |
.690 |
.791 x .772 |
8.75� |
ES2027L |
.875x18tpi |
2.50� |
.690 |
.791 x .772 |
6.50� |
ES2064L |
1.00x18tpi |
2.735� |
.808 |
.773 x .664 |
4.75� |
*ES2011R |
1.00x18tpi |
2.00� |
.808 |
.773 x .664 |
4.12� |
ES2233L |
.875x18tpi |
3.75� |
.808 |
.773 x .664 |
9.75� |
ES2234R |
.875x18tpi |
3.50� |
.808 |
.773 x .664 |
4.75� |
*Book Measurement - All others are actual
measurement of parts. |
click for larger
visit
Parts
Mike for new, used, and rebuilt parts
|