Find us on Facebook



projects & installs
technical & info
reviews & products
off-roading & events
featured products
readers jeeps


decals and lettering by

For the best 4X4 sites on the web check out

and vote for




Main >> Engine >> Factory >> Buick 350 V8

From JeepTech and JeepTech Publishing LLC, the Jeep knowledge base.

All text is available under the terms of the GNU Free Documentation License.



The "Dauntless" Buick 350 V8 uses a cast iron block and cylinder heads with overhead valves and hydraulic lifters. The Buick 350 was used from 1969 until 1970 in J-series pickups and Wagoneers.


Dauntless Buick 350 V8
Bore x Stroke 3.80" x 3.85"
Displacement 350(5.73L)
Compression Ratio 9.0:1
Horsepower (gross) 230@4400
Torque (gross) 350@2400
Main Bearings 5
Valve Configuration OHV
Fuel 2bbl


All text is available under the terms of the GNU Free Documentation License.
Simple HTML for this page here.










Jeep Parts and Accessories
OK Auto 4WD & Tire - Jeep Parts and Accessories


contact us  about
Write for us! We are always looking for informative articles, make an information contribution to the Jeeping community.

DISCLAIMER: Demonstrations and procedures contained in may not provide all necessary or relevant information. Applicable local laws and regulations may vary and should be checked before any project is commenced. Be sure to follow all applicable safety procedures. makes no warranties, expressed or implied, as to the completeness, accuracy, or practicality of any such demonstration or procedure or any information.

Jeep® is a registered trademark of Chrysler Corporation. is not associated with Chrysler Corporation.

The material contained within this web site,, unless otherwise noted may not be reproduced, copied, re-posted or presented in any other media without the prior written approval of the author or
© 1997-2011 Sevenslot Media, LLC All Rights Reserved.